(カテゴリ内:46点)
The U2D2 Power Hub Board combines with the U2D2 to supply a variety of external power sources to DYNAMIXELs.
The board is capable of supplying power to all DYNAMIXELs with the SMPS port, terminal block, and 2P power connector.
The board has holes to fix the U2D2 module and can be assembled using the rivets supplied in the package.
-Easily powers ON/OFF with the power switch
*Robot cable for connecting U2D2 is included.
- Use the Molex-JST Convertible Cable (Use 3P or 4P based on your communication selection)
DYNAMIXEL X-Series, PRO+ Series
- Use the JST Cable. (Use 3P or 4P based on your communication selection)
**This cable is for DYNAMIXEL XW-Series version only**
This is the waterproof Connector to RS-485 4P cable set for Dynamixel XW-series.
XW540-T260-R
XW540-T140-R
MX-106TやMX-106Rをマスタースレーブモードで使用する場合必要な同期ケーブルです。バルクには付属していませんのでバルク購入でマスタースレーブをする場合必要です。
■ DESCRIPTION
- 3P sync cable set for using dual joint mode in Dynamixel models that support the mode.
- Has strong coating to withstand ripping.
Dual Joints
Dual joints are used as 1 joint by controlling 2 motors simultaneously.
To use the dual joints, 1 unit of motor set in master mode and 1 unit of motor set in slave mode are needed.
Next, the motors must be connected to each other using synchronization cable.
Normal mode synch cable: Drives Master and PWM signals synchronized
Reverse mode synch cable: Drives PWM signals in reverse.
Notes : Slave is synchronized by directly receiving the control command through synchronization cable from Master. Slave Mode unit responds to communication through command packets, but data related to motor drive are processed only through the synchronization.
■ PACKAGE CONTENTS
DESCRIPTION
Qty
Robot Cable
3P-Sync 160mm
5
■ COMPATIBLE PRODUCTS
- DYNAMIXEL : MX-106
■ e-Manual
http://support.robotis.com/en/product/dynamixel/mx_series/mx-106.htm
The 6 Port RX/EX Power Hub is a must have accessory for any DYNAMIXEL user working with 4-pin servos.
The DYNAMIXEL communication bus allows you to daisy chain multi servos, making wiring a breeze. However sometimes you need to split your DYNAMIXEL chain into multiple directions. Just plug a 4-Pin Dynamixel Cable from your controller to any port on the hub, and you'll have 5 ports available for DYNAMIXEL's 4-pin servos.
This hub has the added benefit of 2 power breakouts. You can plug in bare wire with the screw terminal block, or plug in power through the DC barrel jack. The 2.1*5.5 female barrel jack will accept any of our SMPS power supplies as well as our Battery Wiring Harness.
The RX/EX Power Hub is compatible with the following DYNAMIXEL servos:
This hub is NOT compatible with the all AX and 3-pin MX series of DYNAMIXEL servos.
*Under certain circumstances, these servos can drop the voltage on Switched Mode Power Supplies. If you are using these servos with an SMPS we recommend also using the SMPS2DYNAMIXEL
The 6 Port AX/MX Power Hub is a must have accessory for any DYNAMIXEL user. This little board is a Bioloid 6 Port Hub and a
お問い合わせ